Need TST frame sliders for my 2022 ninja 400! Thanks
Joined
·
44 Posts
I've installed this set twice. First on my bike than on my wife's bike and a word of advice before you start tearing it apart you might run into the EVAP on the left side. You'll have to delete the EVAP before you can install the slider kit from TST. However, you can buy a resistor here and then use this walkthrough to delete the EVAP stuff.
You don't have to use stands to do the installation. But it makes it easier when it comes to work on the bike. I highly recommend getting a set and sometimes Cycle Gear will have sales in which you can get a set for cheap. If you need some help don't hesitate to reach out to me.
You don't have to use stands to do the installation. But it makes it easier when it comes to work on the bike. I highly recommend getting a set and sometimes Cycle Gear will have sales in which you can get a set for cheap. If you need some help don't hesitate to reach out to me.
Joined
·
14 Posts
you can install the sliders while keeping the evap canister. you just need to move the solenoid and then ziptie the canister to the bracket for the frame slider. It fits almost perfectly there, sadly i don’t have any good photos from when i installed them.
How do I relocate
Joined
·
14 Posts
unbolt the solenoid and canister. remove the metal plates and tuck the canister behind the bar for the frame slider and ziptie it there using the holes drilled into it. You can ziptie the solenoid to somewhere on the frame
Joined
·
14 Posts
yes remove the metalplate with the buckle on it. the canister fits perfectly between the frame slider bar and the frame
Joined
·
14 Posts
red is the canister where it can be zip tied to the metal piece that came with the frame sliders and the yellow is where i kinda stuffed and zip tied the solenoid to
![Hood Automotive tire Motor vehicle Trunk Electrical wiring]()
I think I got it!!! Thank you so much for the quick response 🙌🏽🙌🏽👏🏽👏🏽👏🏽 I was in a jam 😅🤦🏽♀️
New problem. Engine bolt isn’t lining up and not threading. What do I do?
Joined
·
14 Posts
sorry i didn’t see these responses did you manage to fix it? it should line up without a problem unless you undid both of the engine frame bolts at once.
I was able to get it 😅 thank you for reaching out!
1 - 17 of 17 Posts
