Ninja 400 Riders Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter #1 (Edited)
I am installing data acq from Starlane on my little 400 track bike.

I got the TPS breakout harness coming from Kawasaki so I don't have to splice into any wires.

I want to make the same for the rear wheel speed sensor, and wanted to see if anyone knows the model/part number of the connector already?

Not the Kawi 21176-0856, that's the sensor she wiring, I want to build a breakout pigtail splice connector similar to the one available for the TPS.

I will look it up if I need to, no issue, just while I am unable to do the research today and tomorrow, figured I might ask.
 

·
Registered
Joined
·
372 Posts
are you looking for the rear sensor wire et.al itself? I yanked mine off if you need it. I think it works
 

·
Registered
Joined
·
116 Posts
Discussion Starter #3
No, looking to tap into the pulses for the Corsaro-R to detect the wheel speed.
50 pulses per rev from the rear wheel sensor.

I just tapped it off the wire that goes into the dash and it is working properly to allow the Corsaro-R to detect the wheel rotation speed and the gear selection based on rpm/wheel speed ratio.
 
1 - 3 of 3 Posts
Top