Ninja 400 Riders Forum banner

21 - 27 of 27 Posts

·
Registered
2017 Suzuki GSXR1000 2010 Suzuki GSXR600 x2 2018/19 N400
Joined
·
496 Posts
Discussion Starter · #21 ·
Swingarm Pivot Bolt from Spears.....nice little invention !

pivot bolt.jpg
pivot bolt 2.jpg
pivot bolt 3.jpg
 

·
Registered
Joined
·
477 Posts
Ok. Got a question. Been looking at this because crashing happens. So the right side you now got the cotter pin to hold things when you loosen the other side. What happens when you have to take that side off cause there’s no cotter pin holding things on the left side???
 

·
Registered
2017 Suzuki GSXR1000 2010 Suzuki GSXR600 x2 2018/19 N400
Joined
·
496 Posts
Discussion Starter · #23 ·
@Duckman Gregg has given me the fine details of this,but I'm pretty sure the short version is if you go down on the right side and bend the rear set/swingarm bracket all you need to do is remove the nut...otherwise you're pulling the entire rod out which in that point the swing arm will move and then the obvious happens from there ! there now are nuts on both sides as shown in the picture !
 

·
Registered
2017 Suzuki GSXR1000 2010 Suzuki GSXR600 x2 2018/19 N400
Joined
·
496 Posts
Discussion Starter · #24 ·
captive axle blocks installed,keeps the axle block from moving when R&R wheel
captive blocks 2.jpg
captive blocks.jpg
 

·
Registered
2017 Suzuki GSXR1000 2010 Suzuki GSXR600 x2 2018/19 N400
Joined
·
496 Posts
Discussion Starter · #27 ·
yes they work gear and I sell em !
 
21 - 27 of 27 Posts
Top